![图片名称 图片名称](/npublic/img/s.png)
1. Check the microswitch on the side of the frame of the ball tube and image intensifier
2. Open the electrical control cabinet to check whether the wire ends are loose
![图片名称 图片名称](/npublic/img/s.png)
1. Check whether the 125v/10A insurance in the insurance works normally
2. Check whether the filament plate works normally
![图片名称 图片名称](/npublic/img/s.png)
1. Enter the program and check whether it can work in the program
2. If it can work in the program, it is necessary to reset the motion parameters
3, if in the program can not work, remove the case to check the insurance on the machine
![图片名称 图片名称](/npublic/img/s.png)
Go to drive C and open the DROC folder to look for the watch Dog Detelt file. Open the file and click Evalvetioninfo to check the time limit and contact our technical staff
![图片名称 图片名称](/npublic/img/s.png)
![图片名称 图片名称](/npublic/img/s.png)
Possible causes:
1. Check whether the plate is energized
2. Check whether the network connection between the tablet and the computer host is properly connected